Complectation

  1. Ethernet Cable, 5 m, Red marked




  1. Ethernet Cable, 5 m, Blue marked




  1. Ethernet Cable, 15 m, Green marked




  1. Ethernet Cable, 15 m, Yellow marked




  1. Ethernet Cable, 15 m, Not marked




  1. USB-cable, A-B type




  1. Power supply




  1. Controll unit (Big box with switcher)




  1. Connection unit (Small box)




  1. Transmitter unit (Long box with diodes), Red marked




  1. Transmitter unit (Long box with diodes), Blue marked




  1. Receiver unit (Long box with oval foramens), Green marked




  1. Receiver unit (Long box with oval foramens), Yellow marked




Instruction

  1. Install transmitter units (10), (11) on the inner edges of the safety platforms of trampolines. Transmitters should be installed on the closest sides of different trampolines to emit signal in the opposite directions.

  2. Install receiever units in front of each transmitter unit, green marked (12) in pair with red marked transmitter (10), yellow marked receiver (13) in pair with blue marked transmitter (11).

  3. Connect red marked cable (1) to the red marked transmitter unit (10), green marked cable (3) to the green marked receiver unit (12) etc.

  4. Connect blue marked cable (2) to the blue marked port of controll unit (9), yellow marked cable (3) to the yellow marked port of controll unit (9) etc.

  5. Connect the controll unit (8) to the connection unit (9) by not marked cable (5).

  6. Connect the power supply (7) to the connection unit (9).

  7. Download and install all needed software from: http://www.acontests.com/tmd2/#nav-software

  8. Connect the connection unit (9) to the PC by USB-cable (6).